1

I am building aluminum enclousres and my designer used PEM self-clinching studs (3M) and nuts (4M); however, I am not quite sure what tool I need to use to install them. I have read online about a parrell-press being needed but I cannot find any more information on it. Any help would be greatly appreciated.

flag

1 Answer

0

Obviously, this should be closed, but I have an answer.

All clinching during the installation process occurs on the fastener side of the sheet, allowing the reverse side to remain flush and smooth. Using a PEMSERTER® press for best installation results, the nuts are simply placed in punched or drilled holes and then squeezed with sufficient force. Upon installation, the fasteners will not loosen or fall out.

See this for more info.

link|flag

Your Answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.